Robertson County, TN Elevation & Topographic Map

Topographic elevation map of Robertson County, Tennessee, shaded from 390 ft on the west side to 930 ft on the southeast side
Elevation
930 ft 285 m790 ft 240 m730 ft 220 m590 ft 180 m460 ft 140 m390 ft 120 m
Contours every 500 ft, bold every 2,500 ft
USGS 3DEP · U.S. Census Bureau
How to use this mapviews, tools and data
Elevation
Ground colored by height from green (lowest) to white (highest), with contour lines every 40–500 ft (USGS data).
Satellite
A 2016 satellite photo at 33 ft (10 m) detail; contours off.
3D
Tilt and turn the terrain; hills are raised 1.5×, or set ×1 for true height.
Click or tap anywhere
The exact elevation of that spot in ft and m.
Measure
Pick two points for the climb, descent and grade along a straight line.
County area
Fades everything outside the official county boundary (US Census).

Elevation Data

Robertson County averages about 670 ft (205 m) above sea level across all its land. Its ground runs from 390 ft on the west side to 930 ft on the southeast side.

Average elevation
670 ft 205 m
all land inside the county
Highest
930 ft 285 m
on the southeast side
Lowest
390 ft 120 m
on the west side

Robertson County spans about 540 ft of height, so no single spot tells the whole story. The ruler shows where most of its land lies, and where the other numbers you'll see come from.

FigureElevation
Average of all land670 ft205 m
Highest point
Inside the county, on the southeast side
930 ft285 m
Lowest point
Inside the county, on the west side
390 ft120 m

Elevation profile, west to east

27 mi west to east through Springfield.

Topographic Map

Topographic elevation map of Robertson County, Tennessee, shaded from 390 ft on the west side to 930 ft on the southeast side
County boundary (dashed) over shaded terrain, with contours every 40 ft (12 m).
Location
County in Tennessee, United States
Population
78,459 2024 est.
Land area
476.3 sq mi + 0.2 sq mi water
Density
165 per sq mi
Time zone
Central UTC−6 / −5
Landform region
Interior Low Plateaus
Drains to
Gulf of America
⤓ Download this map

WebP, 1200 × 900. Free to use: credit “ElevationOf.com” with a link to this page.

Sources: U.S. Census Bureau, USGS

Nearby Places

All 11 towns in Robertson County by typical elevation
  1. Ridgetop850 ft
  2. White House partly840 ft
  3. Greenbrier820 ft
  4. Portland partly800 ft
  5. Cross Plains720 ft
  6. Orlinda710 ft
  7. Coopertown710 ft
  8. Millersville partly690 ft
  9. Springfield680 ft
  10. Cedar Hill670 ft
  11. Adams560 ft
How we measure
  • Average: every USGS 3DEP bare-earth cell of land inside the Census county boundary (TIGER/Line, Jan 1 2026), weighted equally, on a 1 arc-second (≈100 ft, 30 m) grid. Land means the boundary minus Census area water.
  • Highest and lowest: the highest land cell. Lowest: the lowest land cell; coastal ground within 3 ft (1 m) of named tidal water counts as sea level.
  • Pits: the lowest point is the lowest ground outside closed hollows (quarry floors, mine pits, terrain-model artifacts): any hollow under 0.4 sq mi (1 km²), and any hollow under 2 sq mi (5 km²) whose floor is more than 100 ft (30 m) below its rim; and outside patches below sea level of under 0.4 sq mi (1 km²). The single lowest 3DEP cell, 320 ft at 36.5307° N, 86.8785° W, is in such a hollow or patch and is not counted.
  • Nearby Places: neighboring counties and rankings use each one's average elevation, on its own grid, the same figure its page shows. Peaks and hills: the highest summits inside the county with at least 980 ft (300 m) of prominence, then the highest federal (GNIS) summits inside it when there are fewer than 5; each is the 3DEP top on a ~7 ft (2 m) window, or the NGS published height when a usable survey mark sits within 160 ft (50 m) of it (shown as published).
  • Towns: each town's typical elevation (population-weighted median of its own 2020 blocks at 1 arc-second); a town is listed when any of its 2020 residents live in the county.
  • Rounding: computed heights are rounded to 10 ft (5 m), or to 1 ft (1 m) under 100 ft; 3DEP is good to about a meter, not a foot. Published figures (NGS survey heights) are shown as their publisher gives them.
  • Datum: North American Vertical Datum of 1988 (NAVD 88). NGS plans to replace NAVD 88 with a new datum (NAPGD2022); heights will then shift slightly.
  • Sources: USGS 3DEP, GNIS, Watershed Boundary Dataset and physiographic provinces; U.S. Census Bureau (TIGER boundaries and water, 2020 blocks, 2024 population estimates, county adjacency); NOAA NGS survey heights; BTS time zones. All public domain.