Hamblen County, TN Elevation & Topographic Map

Topographic elevation map of Hamblen County, Tennessee, shaded from 990 ft on the south side to 1,950 ft on the west side
Elevation
1,950 ft 595 m1,710 ft 520 m1,590 ft 485 m1,350 ft 410 m1,110 ft 340 m990 ft 300 m
Contours every 500 ft, bold every 2,500 ft
USGS 3DEP · U.S. Census Bureau
How to use this mapviews, tools and data
Elevation
Ground colored by height from green (lowest) to white (highest), with contour lines every 40–500 ft (USGS data).
Satellite
A 2016 satellite photo at 33 ft (10 m) detail; contours off.
3D
Tilt and turn the terrain; hills are raised 1.5×, or set ×1 for true height.
Click or tap anywhere
The exact elevation of that spot in ft and m.
Measure
Pick two points for the climb, descent and grade along a straight line.
County area
Fades everything outside the official county boundary (US Census).

Elevation Data

Hamblen County averages about 1,260 ft (385 m) above sea level across all its land. Its ground runs from 990 ft on the south side to 1,950 ft on the west side.

Average elevation
1,260 ft 385 m
all land inside the county
Highest
1,950 ft 595 m
on the west side
Lowest
990 ft 300 m
on the south side

Hamblen County spans about 960 ft of height, so no single spot tells the whole story. The ruler shows where most of its land lies, and where the other numbers you'll see come from.

FigureElevation
Average of all land1,260 ft385 m
Highest point
Inside the county, on the west side
1,950 ft595 m
Lowest point
Inside the county, on the south side
990 ft300 m

Elevation profile, south to north

9.6 mi south to north through Morristown.

Topographic Map

Topographic elevation map of Hamblen County, Tennessee, shaded from 990 ft on the south side to 1,950 ft on the west side
County boundary (dashed) over shaded terrain, with contours every 100 ft (30 m).
Location
County in Tennessee, United States
Population
67,715 2024 est.
Land area
161.2 sq mi + 14.6 sq mi water
Density
420 per sq mi
Time zone
Eastern UTC−5 / −4
Landform region
Valley and Ridge
Drains to
Gulf of America
⤓ Download this map

WebP, 1200 × 900. Free to use: credit “ElevationOf.com” with a link to this page.

Sources: U.S. Census Bureau, USGS

Nearby Places

All 2 towns in Hamblen County by typical elevation
  1. Morristown1,340 ft
  2. Russellville1,310 ft
How we measure
  • Average: every USGS 3DEP bare-earth cell of land inside the Census county boundary (TIGER/Line, Jan 1 2026), weighted equally, on a 1 arc-second (≈100 ft, 30 m) grid. Land means the boundary minus Census area water.
  • Highest and lowest: the highest land cell. Lowest: the lowest land cell; coastal ground within 3 ft (1 m) of named tidal water counts as sea level.
  • Pits: the lowest point is the lowest ground outside closed hollows (quarry floors, mine pits, terrain-model artifacts): any hollow under 0.4 sq mi (1 km²), and any hollow under 2 sq mi (5 km²) whose floor is more than 100 ft (30 m) below its rim; and outside patches below sea level of under 0.4 sq mi (1 km²). The single lowest 3DEP cell, 900 ft at 36.1740° N, 83.2001° W, is in such a hollow or patch and is not counted.
  • Nearby Places: neighboring counties and rankings use each one's average elevation, on its own grid, the same figure its page shows. Peaks and hills: the highest summits inside the county with at least 980 ft (300 m) of prominence, then the highest federal (GNIS) summits inside it when there are fewer than 5; each is the 3DEP top on a ~7 ft (2 m) window, or the NGS published height when a usable survey mark sits within 160 ft (50 m) of it (shown as published).
  • Towns: each town's typical elevation (population-weighted median of its own 2020 blocks at 1 arc-second); a town is listed when any of its 2020 residents live in the county.
  • Rounding: computed heights are rounded to 10 ft (5 m), or to 1 ft (1 m) under 100 ft; 3DEP is good to about a meter, not a foot. Published figures (NGS survey heights) are shown as their publisher gives them.
  • Datum: North American Vertical Datum of 1988 (NAVD 88). NGS plans to replace NAVD 88 with a new datum (NAPGD2022); heights will then shift slightly.
  • Sources: USGS 3DEP, GNIS, Watershed Boundary Dataset and physiographic provinces; U.S. Census Bureau (TIGER boundaries and water, 2020 blocks, 2024 population estimates, county adjacency); NOAA NGS survey heights; BTS time zones. All public domain.