Stendal, IN Elevation & Topographic Map

Elevation
630 ft 190 m600 ft 185 m590 ft 180 m560 ft 170 m540 ft 165 m520 ft 160 m
Contours every 40 ft, bold every 200 ft
USGS 3DEP · U.S. Census Bureau
How to use this mapviews, tools and data
- Elevation
- Ground colored by height from green (lowest) to white (highest), with contour lines every 40–500 ft (USGS data).
- Satellite
- A 2016 satellite photo at 33 ft (10 m) detail; contours off.
- 3D
- Tilt and turn the terrain; hills are raised 1.5×, or set ×1 for true height.
- Click or tap anywhere
- The exact elevation of that spot in ft and m.
- Measure
- Pick two points for the climb, descent and grade along a straight line.
- Area
- Fades everything outside the official CDP boundary (US Census).
Elevation Data
Stendal sits at about 620 ft (190 m) above sea level, worked out from 2020 Census block heights on USGS 3DEP, weighted by residents.
Typical elevation
620 ft 190 m
most residents: 610–630 ft
Lowest
520 ft 160 m
on the west side
Highest
630 ft 190 m
near the middle
Average
600 ft 180 m
all land inside the CDP boundary
Stendal spans about 110 ft of height, so no single spot tells the whole story. The ruler shows where its people live, and where the other numbers you'll see come from.
| Figure | Elevation |
|---|---|
| Typical Where people live: half of residents higher, half lower | 620 ft190 m |
| Highest point Inside the CDP boundary, near the middle | 630 ft190 m |
| Lowest point Inside the CDP boundary, on the west side | 520 ft160 m |
| Town center USGS map point for Stendal | 610 ft185 m |
| Average of all land | 600 ft180 m |
Elevation profile, west to east
0.8 mi west to east through the town center.
Topographic Map
- Location
- Unincorporated community (census-designated place) in Pike County, Indiana, United States
- Population
- 53 2020 Census
- Land area
- 0.4 sq mi
- Density
- 142 per sq mi
- Coordinates
- 38.2667° N, 87.1444° W
- Time zone
- Eastern UTC−5 / −4
- Landform region
- Interior Low Plateaus
- Drains to
- Patoka River → Wabash River → Ohio River → Mississippi River → Gulf of America
⤓ Download this map
WebP, 1200 × 900. Free to use: credit “ElevationOf.com” with a link to this page.
Sources: U.S. Census Bureau, USGS
Nearby Places
Nearby towns by typical elevation
- Stendal620 ft
- Lockhart Township540 ft
- Cass Township530 ft
- Holland530 ft
- Marion Township, Pike County500 ft
- Velpen490 ft
- Arthur490 ft
- Spurgeon490 ft
- Monroe Township, Pike County490 ft
- Pigeon Township, Warrick County490 ft
- Lane Township480 ft
Rankings by typical elevation
- Towns in Indiana1,552nd highest of 1,977
- Towns in Pike Countyhighest of 18
Peaks and hills nearest, by height
- Dyson Knob650 ft
- Wilson Hill620 ft
- Ringham Hill610 ft
- Moore Hill, Gibson County590 ft
- Turkey Hill, Pike County560 ft
How we measure
- Typical elevation: the population-weighted median: every 2020 Census block inside the CDP boundary, at its USGS 3DEP height, weighted by the people who live there. Half of residents live higher, half lower.
- Lowest, highest, average: USGS 3DEP bare-earth heights on a 1 arc-second (≈100 ft, 30 m) grid, land only, inside the Census CDP boundary (TIGER, Jan 1 2026).
- Nearby Places: nearby towns and rankings use each town's typical elevation, so every town is compared like for like. Rankings count every city, town, township and census-designated place, including places inside a town. Peaks and hills: the nearest summits with at least 980 ft (300 m) of prominence within 62 mi (100 km), then federal (GNIS) summits within 16 mi (25 km) when there are fewer than 5; each is the 3DEP top on a ~7 ft (2 m) window, or the NGS published height when a usable survey mark sits within 160 ft (50 m) of it (shown as published).
- Rounding: computed heights are rounded to 10 ft (5 m), or to 1 ft (1 m) under 100 ft; 3DEP is good to about a meter, not a foot. Published figures (FAA airport elevation, NGS survey heights) are shown as their publisher gives them.
- Datum: North American Vertical Datum of 1988 (NAVD 88). NGS plans to replace NAVD 88 with a new datum (NAPGD2022); heights will then shift slightly.
- Stendal is an unincorporated community; figures cover the census-designated place, a statistical area.
- Sources: USGS 3DEP, GNIS, Watershed Boundary Dataset and physiographic provinces; U.S. Census Bureau (boundaries, 2020 blocks, Gazetteer areas); BTS time zones. All public domain.