Stewart County, GA Elevation & Topographic Map

Topographic elevation map of Stewart County, Georgia, shaded from 190 ft on the southwest side to 720 ft on the northeast side
Elevation
720 ft 220 m590 ft 180 m520 ft 160 m390 ft 120 m250 ft 80 m190 ft 60 m
Contours every 500 ft, bold every 2,500 ft
USGS 3DEP · U.S. Census Bureau
How to use this mapviews, tools and data
Elevation
Ground colored by height from green (lowest) to white (highest), with contour lines every 40–500 ft (USGS data).
Satellite
A 2016 satellite photo at 33 ft (10 m) detail; contours off.
3D
Tilt and turn the terrain; hills are raised 1.5×, or set ×1 for true height.
Click or tap anywhere
The exact elevation of that spot in ft and m.
Measure
Pick two points for the climb, descent and grade along a straight line.
County area
Fades everything outside the official county boundary (US Census).

Elevation Data

Stewart County averages about 420 ft (130 m) above sea level across all its land. Its ground runs from 190 ft on the southwest side to 720 ft on the northeast side.

Average elevation
420 ft 130 m
all land inside the county
Highest
720 ft 220 m
on the northeast side
Lowest
190 ft 60 m
on the southwest side

Stewart County spans about 530 ft of height, so no single spot tells the whole story. The ruler shows where most of its land lies, and where the other numbers you'll see come from.

FigureElevation
Average of all land420 ft130 m
Highest point
Inside the county, on the northeast side
720 ft220 m
Lowest point
Inside the county, on the southwest side
190 ft60 m

Elevation profile, west to east

24 mi west to east through Richland.

Topographic Map

Topographic elevation map of Stewart County, Georgia, shaded from 190 ft on the southwest side to 720 ft on the northeast side
County boundary (dashed) over shaded terrain, with contours every 40 ft (12 m).
Location
County in Georgia, United States
Population
4,809 2024 est.
Land area
458.8 sq mi + 4.8 sq mi water
Density
10 per sq mi
Time zone
Eastern UTC−5 / −4
Landform region
Coastal Plain
Drains to
Gulf of America
⤓ Download this map

WebP, 1200 × 900. Free to use: credit “ElevationOf.com” with a link to this page.

Sources: U.S. Census Bureau, USGS

Nearby Places

All 2 towns in Stewart County by typical elevation
  1. Richland570 ft
  2. Lumpkin550 ft
How we measure
  • Average: every USGS 3DEP bare-earth cell of land inside the Census county boundary (TIGER/Line, Jan 1 2026), weighted equally, on a 1 arc-second (≈100 ft, 30 m) grid. Land means the boundary minus Census area water.
  • Highest and lowest: the highest land cell. Lowest: the lowest land cell; coastal ground within 3 ft (1 m) of named tidal water counts as sea level.
  • Nearby Places: neighboring counties and rankings use each one's average elevation, on its own grid, the same figure its page shows. Peaks and hills: the highest summits inside the county with at least 980 ft (300 m) of prominence, then the highest federal (GNIS) summits inside it when there are fewer than 5; each is the 3DEP top on a ~7 ft (2 m) window, or the NGS published height when a usable survey mark sits within 160 ft (50 m) of it (shown as published).
  • Towns: each town's typical elevation (population-weighted median of its own 2020 blocks at 1 arc-second); a town is listed when any of its 2020 residents live in the county.
  • Rounding: computed heights are rounded to 10 ft (5 m), or to 1 ft (1 m) under 100 ft; 3DEP is good to about a meter, not a foot. Published figures (NGS survey heights) are shown as their publisher gives them.
  • Datum: North American Vertical Datum of 1988 (NAVD 88). NGS plans to replace NAVD 88 with a new datum (NAPGD2022); heights will then shift slightly.
  • Sources: USGS 3DEP, GNIS, Watershed Boundary Dataset and physiographic provinces; U.S. Census Bureau (TIGER boundaries and water, 2020 blocks, 2024 population estimates, county adjacency); NOAA NGS survey heights; BTS time zones. All public domain.