Banks County, GA Elevation & Topographic Map

Topographic elevation map of Banks County, Georgia, shaded from 610 ft on the southeast side to 1,570 ft on the north side
Elevation
1,570 ft 480 m1,330 ft 405 m1,210 ft 370 m970 ft 295 m730 ft 225 m610 ft 185 m
Contours every 500 ft, bold every 2,500 ft
USGS 3DEP · U.S. Census Bureau
How to use this mapviews, tools and data
Elevation
Ground colored by height from green (lowest) to white (highest), with contour lines every 40–500 ft (USGS data).
Satellite
A 2016 satellite photo at 33 ft (10 m) detail; contours off.
3D
Tilt and turn the terrain; hills are raised 1.5×, or set ×1 for true height.
Click or tap anywhere
The exact elevation of that spot in ft and m.
Measure
Pick two points for the climb, descent and grade along a straight line.
County area
Fades everything outside the official county boundary (US Census).

Elevation Data

Banks County averages about 870 ft (265 m) above sea level across all its land. Its ground runs from 610 ft on the southeast side to 1,570 ft on the north side.

Average elevation
870 ft 265 m
all land inside the county
Highest
1,570 ft 480 m
on the north side
Lowest
610 ft 185 m
on the southeast side

Banks County spans about 960 ft of height, so no single spot tells the whole story. The ruler shows where most of its land lies, and where the other numbers you'll see come from.

FigureElevation
Average of all land870 ft265 m
Highest point
Inside the county, on the north side
1,570 ft480 m
Lowest point
Inside the county, on the southeast side
610 ft185 m

Elevation profile, south to north

16 mi south to north through Maysville.

Topographic Map

Topographic elevation map of Banks County, Georgia, shaded from 610 ft on the southeast side to 1,570 ft on the north side
County boundary (dashed) over shaded terrain, with contours every 100 ft (30 m).
Location
County in Georgia, United States
Population
20,318 2024 est.
Land area
232.4 sq mi + 1.8 sq mi water
Density
87 per sq mi
Time zone
Eastern UTC−5 / −4
Landform region
Piedmont
Drains to
Atlantic Ocean
⤓ Download this map

WebP, 1200 × 900. Free to use: credit “ElevationOf.com” with a link to this page.

Sources: U.S. Census Bureau, USGS

Nearby Places

All 6 towns in Banks County by typical elevation
  1. Baldwin partly1,480 ft
  2. Alto partly1,350 ft
  3. Lula partly1,270 ft
  4. Gillsville partly920 ft
  5. Maysville880 ft
  6. Homer810 ft
How we measure
  • Average: every USGS 3DEP bare-earth cell of land inside the Census county boundary (TIGER/Line, Jan 1 2026), weighted equally, on a 1 arc-second (≈100 ft, 30 m) grid. Land means the boundary minus Census area water.
  • Highest and lowest: the highest land cell. Lowest: the lowest land cell; coastal ground within 3 ft (1 m) of named tidal water counts as sea level.
  • Nearby Places: neighboring counties and rankings use each one's average elevation, on its own grid, the same figure its page shows. Peaks and hills: the highest summits inside the county with at least 980 ft (300 m) of prominence, then the highest federal (GNIS) summits inside it when there are fewer than 5; each is the 3DEP top on a ~7 ft (2 m) window, or the NGS published height when a usable survey mark sits within 160 ft (50 m) of it (shown as published).
  • Towns: each town's typical elevation (population-weighted median of its own 2020 blocks at 1 arc-second); a town is listed when any of its 2020 residents live in the county.
  • Rounding: computed heights are rounded to 10 ft (5 m), or to 1 ft (1 m) under 100 ft; 3DEP is good to about a meter, not a foot. Published figures (NGS survey heights) are shown as their publisher gives them.
  • Datum: North American Vertical Datum of 1988 (NAVD 88). NGS plans to replace NAVD 88 with a new datum (NAPGD2022); heights will then shift slightly.
  • Sources: USGS 3DEP, GNIS, Watershed Boundary Dataset and physiographic provinces; U.S. Census Bureau (TIGER boundaries and water, 2020 blocks, 2024 population estimates, county adjacency); NOAA NGS survey heights; BTS time zones. All public domain.